Instructions on WaterSlide

The Waterslide are all printed on Clear paper. Each image is laser printed in a high quality resolution (no need to be sealed) only thing you need to do is possibly trim it (as you see fit) and add some water for the water slide and just apply it to your awesome item/tumbler. 

The actual design will come without the watermark.

***Each clear WATER SLIDE comes in a Block cut ONLY, as it is much easier to apply, then if the image is cut to close to the design.  If you would like the image to be mirrored please notate that in the NOTE section, all images will come printed upright.

FOR WATER SLIDE APPLICATION:
Please see the instructions below:
1. Cut out the image (unless not in sheet, then the image comes in a block cut)
2. Place it in warm water for approx. 30 Seconds
3. Wet down area on tumbler that you’d like to place the waterslide
4. Slide the waterslide onto the tumbler.
5. Take a damp paper towel and smooth out and wrinkles in the slide.
6. Let completely dry before adding epoxy.